This paper presents upstream nozzle trailing edge coolant ejection on downstream uncooled blades. Pressure sensitive paint (PSP) mass transfer technique provides detailed phantom cooling effectiveness distribution on a modeled land-based turbine rotor blade surfaces. Cavity purge and tip leakage flows are excluded, and a uniform blade inlet temperature is adopted in the current study. Experiments have completed in a low speed wind tunnel facility with a five blade linear cascade. The inlet Reynolds numbers based on chord length are 100,000 and 200,000. Nozzle trailing edge coolant ejection on rotor blade is simulated by a spoked wheel-type rotating facility with 32 hollow rods equipped with coolant ejection from 128 holes per rod. Coolant to mainstream density ratio maintains at 1.5 to match engine conditions. Nozzle coolant discharge velocity to nozzle mainstream velocity ratio varies from 0.4 to 1.4. Velocity ratios from 0.4 to 0.6 are closest to typical engine conditions. Coolant to mainstream mass flow rate ratio (MFR) is from 0.67% to 2.94%. Higher phantom cooling effectiveness occurs on suction and pressure surfaces at the velocity ratio from 0.4 to 0.6 and over 1.0, respectively. Velocity ratio effect impacts on phantom cooling effectiveness distribution more than MFR effect. Most of trailing edge coolant migrates toward blade inner and outer spans than blade mid-span. Further investigation of the trailing edge coolant ejection including cavity purge and tip leakage flows is essential for understanding real applications.
Turbine Blade Surface Phantom Cooling From Upstream Nozzle Trailing Edge Ejection
- Views Icon Views
- Share Icon Share
- Search Site
Li, S, Yang, S, Han, J, Zhang, L, & Moon, H. "Turbine Blade Surface Phantom Cooling From Upstream Nozzle Trailing Edge Ejection." Proceedings of the ASME Turbo Expo 2015: Turbine Technical Conference and Exposition. Volume 5B: Heat Transfer. Montreal, Quebec, Canada. June 15–19, 2015. V05BT12A003. ASME. https://doi.org/10.1115/GT2015-42128
Download citation file: