An intercooling technique using convective cooling channels in the compressor stator vanes has been proposed in recent years. In this paper, two cooling methods are presented and conjugate heat transfer method is used in the numerical simulation to study the effect of cooling on the laminar boundary layer and turbulent boundary layer in compressors. The overall performance of the compressor is also analyzed.

A flat plate in T3C series experiments under adverse pressure gradient has been simulated to verify the aerodynamic simulation and preliminarily investigate the cooling effect. Subsequently, a two-dimensional compressor vane NACA65-(12A2I8b)10 has been numerically simulated to study the cooling effect on two-dimensional boundary layer of the curve surface. The numerical simulation results of the vane without cooling channel are in good agreement with the experiment data by NASA. By comparing it with the case which has convective cooling channels, it can be found that the cooling decreases the size of laminar separation bubble and delays the turbulent separation, which reduces the loss at both the design and off-design angle of attack.

A three-dimensional highly-loaded five-stage axial compressor whose stator vanes have cooling channels and cooling endwalls has also been numerically simulated. The cooling channels and endwalls decrease the temperature rising of the main stream with a slight increase of the pressure rising, which indicates that this intercooling method can be used in the intercooled and recuperated (ICR) cycle. Cooling channels decrease the temperature of the stator vanes and protect them from the high temperature. Besides, the effect of cooling on the turbulent separation in the corner region has also been investigated. The cooling channels decrease the total pressure loss, which indicates that cooling has a beneficial effect on the aerodynamic performance of the compressor.

This content is only available via PDF.
You do not currently have access to this content.