A new experimental dataset focusing on the influence of high free-stream turbulence and large pressure gradients on boundary layer transition is presented. The experiments are conducted in a new wind tunnel equipped with a flat plate test section and a new kind of turbulence generator which allows for a continuous variation of turbulence intensity. The flat plate features an elliptic nose and is mounted midway between contoured top and bottom walls. Two different wall contours can be implemented to create pressure distributions on the flat plate that are typical for the pressure and suction side of high pressure turbine cascades. A large variation of Reynolds number from 3.0 · 105 to 7.5 · 105 and inlet turbulence intensity between 1.1 % and 8 % is realized, resulting in more than 100 test cases. Measurements comprise highly resolved heat transfer, near-wall intermittency and free-stream Reynolds stress distributions. Near-wall intermittency is measured using a traversable hotfilm sensor embedded in a steel-belt that is running around the flat plate while free-stream Reynolds stresses are measured simultaneously at the same position with a revolvable X-wire probe. Additionally, turbulent length scales are analyzed using the X-wire signal along the flat plate. Results show that heat transfer and near wall intermittency distributions are in good agreement and that heat transfer at high turbulence levels increases prior to the formation of first turbulence spots. Transition onset is found to be influenced by the turbulence Reynolds number, i.e. turbulent length scales. At constant inlet turbulence intensity, transition onset moves upstream, when the turbulent Reynolds number is decreased.

This content is only available via PDF.
You do not currently have access to this content.