Skip Nav Destination
1-8 of 8
Keywords: Spray CoolingClose
Proc. ASME. HT2020, ASME 2020 Heat Transfer Summer Conference, V001T12A011, July 13–15, 2020
Paper No: HT2020-9136
...Experimental Investigation on Heat Transfer of Water Spray Cooling by Addition of n-Butanol Chang Cai, Hong Liu*, Han Chen, Chuanqi Zhao, Jiuliang Gao, Ming Jia, Yan an Yan Key Laboratory of Ocean Energy Utilization and Energy Conservation of Ministry of Education, School of Energy and Power...
Proc. ASME. HT2019, ASME 2019 Heat Transfer Summer Conference, V001T08A003, July 14–17, 2019
Paper No: HT2019-3628
...Abstract Abstract In this paper, the performance of a new low-GWP refrigerant R513a was experimentally investigated, during spray cooling. A spray cooling system was designed to work as a sub-system within a closed-loop refrigeration system. The influence of chamber pressure on heat flux...
Proc. ASME. HT2008, Heat Transfer: Volume 2, 727-733, August 10–14, 2008
Paper No: HT2008-56474
...n The tracks of the nozzles were studied during spray cooling with different inclination angles, based on the study of Visaria[1,2] and the critical heat flux (CHF) criterion, which means that CHF will be achieved when the spray is configured on the condition that the spray impact area just...
Proc. ASME. HT2005, Heat Transfer: Volume 2, 179-188, July 17–22, 2005
Paper No: HT2005-72569
... 03 04 2009 Spray cooling is a high flux heat removal technique considered for systems dissipating high power within small areas such as advanced lasers. Recently Selvam and Ponnappan (2004 & 2005) identified the importance of modeling heat transfer in a thin liquid film on a hot...
Proc. ASME. HT2005, Heat Transfer: Volume 4, 743-751, July 17–22, 2005
Paper No: HT2005-72634
... 03 04 2009 Experiments were conducted to study the effects of spray trajectory angles on heat flux for flat and enhanced surface spray cooling. The surface enhancement consisted of straight fins machined on the top surface of a copper heater block. Spray cooling curves were obtained...
Proc. ASME. HT-FED2004, Volume 3, 661-666, July 11–15, 2004
Paper No: HT-FED2004-56410
... and maintain perature variations within acceptable limits. A new nique for designing and analyzing two-phase thermal agement systems for solid-state lasers has been developed. word: Spray Cooling, Two Phase, Thermal Management, de Pumped Solid State Lasers NOMENCLATURE k Thermal Conductivity (W/mK) h Heat...
Proc. ASME. HT2003, Heat Transfer: Volume 3, 355-359, July 21–23, 2003
Paper No: HT2003-47585
... parameters.The application of obtained results is expected for high temperature cooling especially in continuous casting. Leidenfrost temperature spray cooling heat transfer spray parameters Proceedings of 2003 ASME Summer Heat Transfer Conference July 21 23, 2003, Las Vegas, Nevada, USA u...
Proc. ASME. HT2003, Heat Transfer: Volume 3, 495-500, July 21–23, 2003
Paper No: HT2003-47297
... to the upstream heaters was turned off. The heat removal at the “leading” heater at a specific uniform heater temperature is shown to depend on the subcooling of liquid for both orientations. Spray cooling dielectric liquid ASIC li o g tr is r p to th s o K N Q qquid temperature which is consistent...