This study is motivated by the need for an efficient and accurate tool to analyze the wave field produced by localized dynamic sources on the surface or the interior of isotropic plates and anisotropic composite laminates. A semi-analytical method based on the wave number integral representation of the elastodynamic field is described that reduces the overall computational effort significantly over other available methods. This method is used to calculate the guided wave field produced in a thin unidirectional graphite/epoxy composite laminate by a dynamic surface point load. The results are compared with those obtained from a finite element analysis, showing excellent agreement, except for minor differences at higher frequencies. A recently discovered feature of the calculated surface motion, namely, a spatially periodic “phase reversal” of the main pulse with propagation distance, is observed in both cases. The present work is expected to be helpful in developing impact damage monitoring systems in defect-critical structural components through real time analysis of acoustic emission wave forms.
Calculation of the Response of a Composite Plate to Localized Dynamic Surface Loads Using a New Wave Number Integral Method
Contributed by the Applied Mechanics Division of THE AMERICAN SOCIETY OF MECHANICAL ENGINEERS for publication in the ASME JOURNAL OF APPLIED MECHANICS. Manuscript received by the Applied Mechanics Division, May 12, 2003; final revision, July 7, 2004. Editor: K. Ravi-Chandar. Discussion on the paper should be addressed to the Editor, Prof. Robert M. McMeeking, Journal of Applied Mechanics, Department of Mechanical and Environmental Engineering, University of California—Santa Barbara, Santa Barbara, CA 93106-5070, and will be accepted until four months after final publication in the paper itself in the ASME JOURNAL OF APPLIED MECHANICS.
- Views Icon Views
- Share Icon Share
- Search Site
Banerjee, S., Prosser, W., and Mal, A. (February 1, 2005). "Calculation of the Response of a Composite Plate to Localized Dynamic Surface Loads Using a New Wave Number Integral Method ." ASME. J. Appl. Mech. January 2005; 72(1): 18–24. https://doi.org/10.1115/1.1828064
Download citation file: