Gas turbines fueled by integrated biomass gasifiers are a promising option for base load electricity generation from a renewable resource. Aeroderivative turbines, which are characterized by high efficiencies at smaller scales, are of special interest because transportation costs for biomass constrain biomass conversion facilities to relatively modest scales. Commercial development activities and major technological issues associated with biomass integrated-gasifier/gas turbine (BIG/GT) combined cycle power generation are reviewed in Part A of this two-part paper. Also, the computational model and the assumptions used to predict the overall performance of alternative BIG/GT cycles are outlined. The model evaluates appropriate value of key parameters (turbomachinery efficiencies, gas turbine cooling flows, steam production in the heat recovery steam generator, etc.) and then carries out energy, mass, and chemical species balances for each plant component, with iterations to insure whole-plant consistency. Part B of the paper presents detailed comparisons of the predicted performance of systems now being proposed for commercial installation in the 25–30 MWe power output range, as well as predictions for advanced combined cycle configurations (including with intercooling) with outputs from 22 to 75 MWe. Finally, an economic assessment is presented, based on preliminary capital cost estimates for BIG/GT combined cycles.
Skip Nav Destination
Article navigation
July 1996
Research Papers
Biomass-Gasifier/Aeroderivative Gas Turbine Combined Cycles: Part A—Technologies and Performance Modeling
S. Consonni,
S. Consonni
Dipartimento di Energetica, Politecnico di Milano, Milan, Italy
Search for other works by this author on:
E. D. Larson
E. D. Larson
Center for Energy and Environmental Studies, School of Engineering and Applied Science, Princeton University, Princeton, NJ 08544
Search for other works by this author on:
S. Consonni
Dipartimento di Energetica, Politecnico di Milano, Milan, Italy
E. D. Larson
Center for Energy and Environmental Studies, School of Engineering and Applied Science, Princeton University, Princeton, NJ 08544
J. Eng. Gas Turbines Power. Jul 1996, 118(3): 507-515 (9 pages)
Published Online: July 1, 1996
Article history
Received:
May 1, 1995
Online:
November 19, 2007
Citation
Consonni, S., and Larson, E. D. (July 1, 1996). "Biomass-Gasifier/Aeroderivative Gas Turbine Combined Cycles: Part A—Technologies and Performance Modeling." ASME. J. Eng. Gas Turbines Power. July 1996; 118(3): 507–515. https://doi.org/10.1115/1.2816677
Download citation file:
Get Email Alerts
Burner and Flame Transfer Matrices of Jet Stabilized Flames: Influence of Jet Velocity and Fuel Properties
J. Eng. Gas Turbines Power
Towards Low NOx Emissions Performance of A 65KW Recuperated Gas Turbine Operated on 100% Hydrogen
J. Eng. Gas Turbines Power
A Large Eddy Simulation Study on Hydrogen Microjets in Hot Vitiated Crossflow
J. Eng. Gas Turbines Power
Related Articles
Biomass-Gasifier/Aeroderivative Gas Turbine Combined Cycles: Part B—Performance Calculations and Economic Assessment
J. Eng. Gas Turbines Power (July,1996)
Exergy Analysis of Combined Cycles Using Latest Generation Gas Turbines
J. Eng. Gas Turbines Power (April,2000)
A Computational Model of a Combined Cycle Power Generation Unit
J. Energy Resour. Technol (September,2004)
Evaluation of Design Performance of the Semi-Closed Oxy-Fuel Combustion Combined Cycle
J. Eng. Gas Turbines Power (November,2012)
Related Chapters
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration
Performance Testing of Combined Cycle Power Plant
Handbook for Cogeneration and Combined Cycle Power Plants, Second Edition
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential