As commercial and military aircraft engines approach higher total temperatures and increasing overall fuel-to-air ratios, the potential for significant chemical reactions on a film-cooled surface is enhanced. Currently, there is little basis for understanding the effects on aero-performance and durability due to such secondary reactions. A shock tube experiment was employed to generate short duration, high temperature (1000–2800 K) and pressure (6 atm) flows over a film-cooled flat plate. The test plate contained two sets of 35 deg film cooling holes that could be supplied with different gases, one side using air and the other nitrogen. A mixture of ethylene and argon provided a fuel rich freestream that reacted with the air film resulting in near wall reactions. The relative increase in surface heat flux due to near wall reactions was investigated over a range of fuel levels, momentum blowing ratios (0.5–2.0), and Damko¨hler numbers (ratio of flow to chemical time scales) from near zero to 30. For high Damko¨hler numbers, reactions had sufficient time to occur and increased the surface heat flux by 30 percent over the inert cooling side. When these results are appropriately scaled, it is shown that in some situations of interest for gas turbine engine environments significant increases in surface heat flux can be produced due to chemical reactions in the film-cooling layer. It is also shown that the non-dimensional parameters Damko¨hler number (Da), blowing ratio (B), heat release potential (H*), and scaled heat flux are the appropriate quantities to predict the augmentation in surface heat flux that arises due to secondary reactions.
Skip Nav Destination
Article navigation
July 2003
Technical Papers
Gas Turbine Engine Durability Impacts of High Fuel-Air Ratio Combustors—Part II: Near-Wall Reaction Effects on Film-Cooled Heat Transfer
D. R. Kirk, Graduate Research Assistant,
D. R. Kirk, Graduate Research Assistant
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
Search for other works by this author on:
G. R. Guenette, Principal Research Engineer,
G. R. Guenette, Principal Research Engineer
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
Search for other works by this author on:
S. P. Lukachko, Research Engineer,
S. P. Lukachko, Research Engineer
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
Search for other works by this author on:
I. A. Waitz, Professor of Aeronautics and Astronautics
I. A. Waitz, Professor of Aeronautics and Astronautics
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
Search for other works by this author on:
D. R. Kirk, Graduate Research Assistant
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
G. R. Guenette, Principal Research Engineer
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
S. P. Lukachko, Research Engineer
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
I. A. Waitz, Professor of Aeronautics and Astronautics
Gas Turbine Laboratory, Department of Aeronautics and Astronautics, Massachusetts Institute of Technology, Cambridge, MA 02139
Contributed by the International Gas Turbine Institute and presented at the International Gas Turbine and Aeroengine Congress and Exhibition, Amsterdam, The Netherlands, June 3–6, 2002. Manuscript received by the IGTI, November 27, 2001. Paper No. 2002-GT-30182 Review Chair: E. Benvenuti.
J. Eng. Gas Turbines Power. Jul 2003, 125(3): 751-759 (9 pages)
Published Online: August 15, 2003
Article history
Received:
November 27, 2001
Online:
August 15, 2003
Citation
Kirk, D. R., Guenette, G. R., Lukachko, S. P., and Waitz, I. A. (August 15, 2003). "Gas Turbine Engine Durability Impacts of High Fuel-Air Ratio Combustors—Part II: Near-Wall Reaction Effects on Film-Cooled Heat Transfer ." ASME. J. Eng. Gas Turbines Power. July 2003; 125(3): 751–759. https://doi.org/10.1115/1.1606473
Download citation file:
Get Email Alerts
Shape Optimization of an Industrial Aeroengine Combustor to reduce Thermoacoustic Instability
J. Eng. Gas Turbines Power
Dynamic Response of A Pivot-Mounted Squeeze Film Damper: Measurements and Predictions
J. Eng. Gas Turbines Power
Review of The Impact Of Hydrogen-Containing Fuels On Gas Turbine Hot-Section Materials
J. Eng. Gas Turbines Power
Effects of Lattice Orientation Angle On Tpms-Based Transpiration Cooling
J. Eng. Gas Turbines Power
Related Articles
Gas Turbine Engine Durability Impacts of High Fuel-Air Ratio Combustors: Near Wall Reaction Effects on Film-Cooled Backward-Facing Step Heat Transfer
J. Eng. Gas Turbines Power (April,2006)
Effects of a Reacting Cross-Stream on Turbine Film Cooling
J. Eng. Gas Turbines Power (May,2010)
Gas Turbine Engine Durability Impacts of High Fuel-Air Ratio Combustors—Part I: Potential for Secondary Combustion of Partially Reacted Fuel
J. Eng. Gas Turbines Power (July,2003)
High-Resolution Measurements of Local Heat Transfer Coefficients From Discrete Hole Film Cooling
J. Turbomach (October,2001)
Related Proceedings Papers
Related Chapters
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Control and Operational Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Introduction
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration