A theoretical analysis is performed to predict the effects of a fluid with temperature-dependent viscosity flowing through an isoflux-bounded porous medium channel. For validation purposes, the thermo-hydraulic behavior of this system is obtained also by solving numerically the differential balance equations. The conventional procedure for predicting the numerical pressure-drop along the channel by using the global Hazen-Dupuit-Darcy (HDD) model (also known as the Forchheimer-extended Darcy model), with a representative viscosity for the channel calculated at maximum or minimum fluid temperatures, is shown to fail drastically. Alternatively, new predictive theoretical global pressure-drop equations are obtained using the differential form of the HDD model, and validated against the numerical results. Heat transfer results from the new theory, in the form of Nusselt numbers, are compared with earlier results for Darcy flow models (with and without viscosity variation), and validated by using the numerical results. Limitations of the new theory are highlighted and discussed.

Issue Section:
Forced Convection
Keywords:
forced convection, flow through porous media, channel flow, Analytical, Forced Convection, Heat Transfer, Porous Media, Viscous
Topics:
Fluids, Horizontal directional drilling, Porous materials, Temperature, Viscosity, Forced convection, Flow (Dynamics), Pressure drop
1.
Kaviany, M., 1991, Principles of Heat Transfer in Porous Media, Springer-Verlag, NY.
2.
Nield, D. A., and Bejan, A., 1999, Convection in Porous Media, 2nd ed., Springer-Verlag, NY.
3.
Lauriat, G., and Vafai, K., 1991, “Forced Convective Flow and Heat Transfer Through a Porous Medium Exposed to a Flat Plate or a Channel,” Convective Heat and Mass Transfer in Porous Media, S. Kakac¸ et al., eds., Kluwer, Dordrecht, pp. 289–327.
4.
Lauriat, G., and Ghafir, R., 2000, “Forced Convective Heat Transfer in Porous Medium,” Handbook of Porous Media, K. Vafai, ed., Marcel-Dekker, NY, pp. 201–268.
5.
Lage, J. L., and Narasimhan, A., 2000, “Porous Media Enhanced Forced Convection: Fundamentals and Applications,” Handbook of Porous Media, K. Vafai, ed., Marcel-Dekker, NY, pp. 357–394.
6.
Xie
,
C.
, and
Hartnett
,
J. P.
,
1992
, “
Influence of Variable Viscosity of Mineral Oil on Laminar Heat Transfer in a 2:1 Rectangular Duct
,”
Int. J. Heat Mass Transf.
,
35
, pp.
641
–
648
.
7.
Shin
,
S.
,
Cho
,
Y. I.
,
Gringrich
,
W. K.
, and
Shyy
,
W.
,
1993
, “
Numerical Study of Laminar Heat Transfer With Temperature Dependent Fluid Viscosity in a 2:1 Rectangular Duct
,”
Int. J. Heat Mass Transf.
,
36
, pp.
4365
–
4373
.
8.
Lage
,
J. L.
,
Weinert
,
A. K.
,
Price
,
D. C.
, and
Weber
,
R. M.
,
1996
, “
Numerical Study of a Low Permeability Microporous Heat Sink for Cooling Phased-Array Radar Systems
,”
Int. J. Heat Mass Transf.
,
39
, pp.
3633
–
3647
.
9.
Antohe
,
B. V.
,
Lage
,
J. L.
,
Price
,
D. C.
, and
Weber
,
R. M.
,
1997
, “
Experimental Determination of Permeability and Inertia Coefficients of Mechanically Compressed Aluminum Porous Matrices
,”
ASME J. Fluids Eng.
,
119
, pp.
404
–
412
.
10.
Anjani
,
K.
, and
Rao
,
N. S.
,
1994
, “
Stability of a Rigid Rotor in Turbulent Hybrid Porous Journal Bearings
,”
Tribol. Int.
,
27
, pp.
299
–
305
.
11.
Kumar
,
A.
,
1998
, “
Conical Whirl Instability of Turbulent Flow Hybrid Porous Journal Bearings
,”
Tribol. Int.
,
31
, pp.
235
–
243
.
12.
Lin
,
J. R.
, and
Hwang
,
C. C.
,
1994
, “
Static and Dynamic Characteristics of Long Porous Journal Bearings: Use of the Brinkman-Extended Darcy Model
,”
J. Phys. D
,
27
, pp.
634
–
643
.
13.
Ling
,
J. X.
, and
Dybbs
,
A.
,
1992
, “
The Effect of Variable Viscosity on Forced Convection over a Flat Plate Submersed in a Porous Medium
,”
ASME J. Heat Transfer
,
114
, pp.
1063
–
1065
.
14.
Nield
,
D. A.
,
Porneala
,
D. C.
, and
Lage
,
J. L.
,
1999
, “
A Theoretical Study, With Experimental Verification of the Viscosity Effect on the Forced Convection Through a Porous Medium Channel
,”
ASME J. Heat Transfer
,
121
, pp.
500
–
503
.
15.
Narasimhan
,
A.
, and
Lage
,
J. L.
,
2001
, “
Modified Hazen-Dupuit-Darcy Model for Forced Convection of a Fluid With Temperature-Dependent Viscosity
,”
ASME J. Heat Transfer
,
123
, pp.
31
–
38
.
16.
Kioupis
,
L. I.
, and
Maginn
,
E. J.
,
1999
, “
Molecular Simulation of Poly-α-olefin Synthetic Lubricants: Impact of Molecular Architecture on Performance Properties
,”
J. Phys. Chem. B
,
103
, pp.
10781
–
10790
.
17.
Lage, J. L., Price, D. C., Weber, R. M., Schwartz, G. J., and McDaniel, J., 1999, Improved Cold Plate Design for Thermal Management of Phased Array Radar Systems, US Patent Office, Patent no. 5960861.
18.
Lage
,
J. L.
,
Antohe
,
B. V.
, and
Nield
,
D. A.
,
1997
, “
Two Types of Nonlinear Pressure-Drop Versus Flow-Rate Relation Observed for Saturated Porous Media
,”
ASME J. Fluids Eng.
,
119
, pp.
700
–
706
.
19.
White, F. M., 1991, Viscous Fluid Flow, 2nd ed., McGraw Hill, NY.
20.
Darby, R., 1996, Chemical Engineering Fluid Mechanics, Marcel-Dekker, NY.
21.
Maginn, E. J., 1999, private communications.
22.
Chevron, 1981, Synfluid Synthetic Fluids, Physical Property Data.
Copyright © 2001
 by ASME
You do not currently have access to this content.