1-9 of 9
Keywords: fins
Close
Follow your search
Access your saved searches in your account

Would you like to receive an alert when new items match your search?
Close Modal
Sort by
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Heat Mass Transfer. September 2014, 136(9): 091901.
Paper No: HT-13-1596
Published Online: June 12, 2014
... 07 05 2014 Fins are essentially used in diverse engineering applications to increase the heat transfer between the hot and cold media. In this paper, a technique for computing the analytic approximate solution of the nonlinear differential equations resulting from heat transfer problems...
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Heat Mass Transfer. August 2013, 135(8): 082701.
Paper No: HT-12-1398
Published Online: July 18, 2013
... 04 2013 The performance of tree-like fins with varying bifurcation angle, surface emissivity, material, width-to-thickness ratio, and base heat rate was examined. Overall system performance was examined computationally. The computational results have been validated, verified, and cast...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. March 2012, 134(3): 031007.
Published Online: January 11, 2012
... is adopted and applied to a number of industrial applications ranging from flat plates of electroluminecence displays to the optimization of heat transfer in fins, fin arrays and mobile phones. In the paper, the approach is explained and applied to some classical conjugated problems. In addition, solutions...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. August 2011, 133(8): 081902.
Published Online: May 2, 2011
... geometry of a complex assembly of fins, i.e., an assembly where there is a cavity between the two branches of the T-Y-assembly of fins and two additional extended surfaces. The global thermal resistance of the assembly is minimized four times by geometric optimization subject to the following constraints...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. July 2011, 133(7): 071801.
Published Online: April 6, 2011
... removing fin modules, comparing their performances when operating with different types of fluids. In particular, the simulations involve air and water (as representative of gases and liquids), to understand the actual benefits of employing a less heat conductive fluid involving smaller pressure losses...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Heat Mass Transfer. October 2010, 132(10): 104503.
Published Online: July 28, 2010
...A.-R. A. Khaled This work considers heat transfer in fin-thin film systems. Two types of these systems are analyzed: (A) a thin film sandwiched between two identical fin halves, and (B) a fin sandwiched between two identical thin films. The corresponding coupled energy equations are solved...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Heat Mass Transfer. July 2008, 130(7): 074503.
Published Online: May 20, 2008
...A.-R. A. Khaled Heat transfer through solar fins and rooted fins is analyzed theoretically in this work. The terminology of “solar fin” is used to refer to fins that are subject to external irradiations while the terminology “rooted fin” is used to refer to fins partially embedded in the base wall...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Heat Mass Transfer. August 2007, 129(8): 1052–1059.
Published Online: January 18, 2007
... fins, to the heated surface. In the current work, spray cooling of high-aspect-ratio open microchannels was explored, which substantially increases the total surface area and allows more residence time for the incoming liquid to be heated by the wall. Five such heat sinks were constructed...