1-15 of 15
Keywords: thermocouples
Close
Sort by
Journal Articles
Publisher: ASME
Article Type: Research-Article
J. Heat Mass Transfer. July 2013, 135(7): 072502.
Paper No: HT-12-1418
Published Online: June 17, 2013
... prediction, whereas the highly eccentric-case Nusselt number was significantly lower than that. mixed convection natural convection forced convection annulus annular channel eccentricity thermocouples Natural and mixed convection in vertical channels have received considerable attention...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. January 2012, 134(1): 011902.
Published Online: November 21, 2011
... heating is measured using hot-wire anemometry. Finally, the thermal boundary layer over the steadily heated plate is measured using a thermocouple probe. Because of the constant flux experimental configuration, the protuberances provide negligible heat flux augmentation. Consequently, the variation...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. December 2011, 133(12): 122203.
Published Online: October 7, 2011
... by reporting the heater thermal image obtained by an infrared camera, the inlet and outlet flow temperature via thermocouples, the flow rate via rotameter, and the pressure drop across the inlet and outlet flow via pressure transducers. The single enclosed jet flow is used to create a single cyclone inside...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. December 2011, 133(12): 122503.
Published Online: October 5, 2011
... 13 06 2011 05 10 2011 05 10 2011 channel flow flow measurement mass transfer natural convection natural convection annular channel eccentricity thermocouples Heat exchangers are essential parts of many engineering systems, including heating, ventilating, and air...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. August 2011, 133(8): 082502.
Published Online: May 4, 2011
...Parviz Merati; Charles Davis; K.-H. Chen; J. P. Johnson Particle image velocimetry and thermal measurements using thermocouples are used to measure the buoyant flow of a simplified full-scale model of an engine compartment. The engine block surface temperature and exhaust heaters are kept at about...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. August 2011, 133(8): 081602.
Published Online: May 3, 2011
...Lina Zhu; Guangjun Wang; Hong Chen; Zhaoming Luo This study provides a new inverse approach based on fuzzy inference for solving the problem of estimating heat flux distribution at the metal-mold interface in the continuous casting process. Measured temperatures acquired with the thermocouples...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. July 2011, 133(7): 071501.
Published Online: April 1, 2011
... the use of surfactant. Quench probes with a diameter of 20 mm and a length of 50 mm were prepared from 304L stainless steel. Thermocouples were fixed at the selected location inside the quench probes and the probes were quenched in distilled water and CNT nanofluids. During quenching, time-temperature...
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Heat Mass Transfer. November 2008, 130(11): 114501.
Published Online: August 28, 2008
... indium tin oxide (ITO) layer commercially deposited on a fused quartz substrate. Four copper-nickel thin film thermocouples (TFTCs) on the heater surface measured the surface temperature, while a thin layer of sapphire or synthetic fused silica provided electrical insulation between the TFTCs and the ITO...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. September 2008, 130(9): 091601.
Published Online: July 3, 2008
... as an efficient calibration tool for near-field thermal probes. Finally, an example of temperature measurements on a microhotplate has been presented, showing the potential of miniaturized wire thermocouples to perform thermal measurements on microscale object. We have calibrated a thermocouple cantilever...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. March 2008, 130(3): 032301.
Published Online: March 6, 2008
... through two parallel templates with holes drilled on a 5 × 5 mm 2 mesh. The temperature of the active segment of the probe was monitored by a single soldered thermocouple (TC). Temperatures in the gel were monitored by K-type TC strings in the radial, and in the downward and upward axial directions...
Journal Articles
Publisher: ASME
Article Type: Technical Notes
J. Heat Mass Transfer. April 2005, 127(4): 434–440.
Published Online: March 30, 2005
... a compound angle of 45 deg with respect to the high temperature air flow direction. Both geometries were tested over a blowing ratio range of 0.7 to 4.0 Surface temperatures were measured along four longitudinal rows of thermocouples covering the downstream area between two adjacent holes. The results showed...
Journal Articles
Publisher: ASME
Article Type: Research Papers
J. Heat Mass Transfer. August 2004, 126(4): 535–539.
Published Online: April 20, 2004
...T. C. Tszeng; G. F. Zhou The present paper addresses the measurement errors in temperature due to the effects of surface-mounted temperature sensors like thermocouples. Heat conduction into or from the installed thermocouple wires can alter the temperature at the thermocouple junction as well...
Journal Articles
Publisher: ASME
Article Type: Technical Papers
J. Heat Mass Transfer. October 2003, 125(5): 926–935.
Published Online: September 23, 2003
...T. C. Tszeng; V. Saraf The present study addresses the effects of thermocouples on the measured temperature when such thermocouples are mounted directly on the surface of the object. A surface-mounted thermocouple is a very convenient way of measuring the surface temperature. However, the heat...
Journal Articles
Journal Articles
Publisher: ASME
Article Type: Technical Briefs
J. Heat Mass Transfer. May 1998, 120(2): 525–528.
Published Online: May 1, 1998
... Thermocouples ASTM, 1981, Manual on the Use of Thermocouples in Temperature Measurement , STP 470B. Bott, T. R., 1995, The Fouling of Heat Exchangers , Elsevier, Amsterdam, The Netherlands. Cho Y. I. , Fan C. F. , and Choi B. G. , 1997 a, “ Theory of Electronic Anti-Fouling...