... was validated by comparing the resulting process forces measured during end milling with the natural and contrived worn tool for different path strategies. Finally, a qualitative finite element (FE) analysis was conducted, and specific force coefficients for worn tool segments were determined through simulation...

...Ankit Agarwal; K. A. Desai This article presents a novel approach to optimize geometric tolerances (flatness and cylindricity) by manipulating the rigidity among finishing and roughing cutting sequences during end milling of thin-walled components. The proposed approach considers the design...

...Masahiko Sato; Naoki Tamura; Hisataka Tanaka This paper describes the cyclic temperature variation beneath the rake face of a cutting tool in end milling. A newly developed infrared radiation pyrometer equipped with two optical fibers is used to measure the temperature. A small hole is drilled...

... interface. In end milling with the oil mist applied, the tool temperature at the flank face is ∼ 580 ° C at a cutting speed of 400 m/min, though in dry cutting it is ∼ 660 ° C . 03 03 2004 24 02 2005 cutting cutting tools carbon steel turning (machining) alumina pyrometers milling...