Stress and fracture analysis of ceramic-lined cannon pressure vessels is described, for a or SiC liner and A723 steel or carbon-epoxy jacket and with an initial residual interface pressure between liner and jacket and pressure applied to the bore. Room temperature stresses for a steel jacket over ceramic are similar to those for a carbon-epoxy jacket, but both radial and hoop jacket stresses can exceed typical carbon-epoxy strength values. Elevated temperature liner stresses are reduced for a carbon-epoxy jacket, due to the effective increase in interface pressure caused by differential thermal expansion. Critical crack sizes for brittle fracture are generally very small, albeit larger for than SiC due to lower liner stresses and higher fracture toughness for
Skip Nav Destination
Article navigation
November 2004
Research Papers
Stress and Fracture Analysis of Ceramic Lined, Composite or Steel Jacketed Pressure Vessels
John H. Underwood,
John H. Underwood
Army Armaments Engineering & Technology Center, Bene´t Laboratories, Watervliet, NY 12189, USA
Search for other works by this author on:
Anthony P. Parker
Anthony P. Parker
Royal Military College of Science, Cranfield University, Swindon, SN6 8LA, England
Search for other works by this author on:
John H. Underwood
Army Armaments Engineering & Technology Center, Bene´t Laboratories, Watervliet, NY 12189, USA
Anthony P. Parker
Royal Military College of Science, Cranfield University, Swindon, SN6 8LA, England
Contributed by the Pressure Vessels and Piping Division for publication in the JOURNAL OF PRESSURE VESSEL TECHNOLOGY. Manuscript received by the PVP Division August 4, 2004; revision received August 18, 2004. Review conducted by: S. Zamrik.
J. Pressure Vessel Technol. Nov 2004, 126(4): 485-488 (4 pages)
Published Online: December 1, 2004
Article history
Received:
August 4, 2004
Revised:
August 18, 2004
Online:
December 1, 2004
Citation
Underwood, J. H., and Parker, A. P. (December 1, 2004). "Stress and Fracture Analysis of Ceramic Lined, Composite or Steel Jacketed Pressure Vessels ." ASME. J. Pressure Vessel Technol. November 2004; 126(4): 485–488. https://doi.org/10.1115/1.1811109
Download citation file:
Get Email Alerts
Cited By
The Behavior of Elbow Elements at Pure Bending Applications Compared to Beam and Shell Element Models
J. Pressure Vessel Technol (February 2025)
Related Articles
Mechanisms and Modeling Comparing HB7 and A723 High Strength Pressure Vessel Steels
J. Pressure Vessel Technol (November,2004)
Effect of Loading Rate on Fracture Toughness of Pressure Vessel Steels
J. Pressure Vessel Technol (May,2000)
Increased Temperature Margins Due to Constraint Loss
J. Pressure Vessel Technol (May,2005)
Estimation of Master Curve Based RT TO Reference Temperature From CVN Data
J. Pressure Vessel Technol (August,2007)
Related Proceedings Papers
Related Chapters
Section VIII: Division 2–Alternative Rules
Companion Guide to the ASME Boiler & Pressure Vessel Codes, Volume 2, Sixth Edition
Applications of Elastic-Plastic Fracture Mechanics in Section XI, ASME Code Evaluations
Online Companion Guide to the ASME Boiler & Pressure Vessel Codes
Section XI Flaw Acceptance Criteria and Evaluation Using Code Procedures
Online Companion Guide to the ASME Boiler & Pressure Vessel Codes